Fadye Atelier

Terrain Studies

Read these studies in the order their terrain was made. Begin with the edge that has to remain recognisable, then look at what happens when the camera changes position. Each study links to the corresponding part of its concept and to a second use of the same principle.

Start the hinge from a single hard edge

The Hinged Ridge uses a shallow face beside a much taller flank. A rough first block establishes where the pieces overlap. The second pass removes unnecessary bevels and leaves an identifiable peak and a longer edge the explorer can use to compare positions.

  1. Find the projecting edge from the normal approach. The ridge reference shows the useful skyline before either part turns.
  2. Rotate one face until the edge uncovers the first half of the pass. Keep the other face readable while comparing the new position.
  3. Try the assembled route and check the comparable lower view at the quarry. A skyline match is enough to choose a place to inspect, while continuity has to be checked along the ground.

Cut a recess before rotating the stair

Under the Cut starts with an oblique slab that hides the lowest step. Before adding texture, the model needs a recess that survives a change in camera angle. A plain stone face can be enough if its rim remains readable from the lower work platform.

  1. Follow the slope to the recessed platform and mark the first visible break in the rock.
  2. Open the low view and rotate within the small permitted range.
  3. When the step comes into sight, compare it with the original skyline exercise. The quarry rewards using a second position before turning.

At each inspection point, find which edge stays available from the previous view. A shared reference lets you check the adjustment after walking somewhere else.